Changeset 2 for trunk/firmware/CubeMX

Timestamp:

Apr 19, 2023, 1:25:34 PM (3 years ago)

Author:

f.jahn

Message:

Precharge pulses are made as short as possible.

Location:

trunk/firmware/CubeMX

Files:

• Inc/main.h (modified) (1 diff)
• Src/main.c (modified) (2 diffs)

trunk/firmware/CubeMX/Inc/main.h

@@ -125 +125 @@
 #define BTN1_Pin GPIO_PIN_15
 #define BTN1_GPIO_Port GPIOA
-#define OUT_CTRL_Pin GPIO_PIN_1
+#define OUT_CTRL_Pin GPIO_PIN_0
 #define OUT_CTRL_GPIO_Port GPIOD
 #define SW_OFF_Pin GPIO_PIN_2

trunk/firmware/CubeMX/Src/main.c

@@ -1978 +1978 @@
 void StartAutoMode(void)
 {
-
         uint32_t current_time = HAL_GetTick();
 
@@ -2340 +2339 @@
 
                 // Sliding average calculation for board temperature
-                current_temperature = (((MAX_TEMP - MIN_TEMP)*((int)ADC_values[TEMP_CHANNEL] - TEMP_SENSOR_ADC_AT_MINUS30))/(TEMP_SENSOR_ADC_AT_PLUS100 - TEMP_SENSOR_ADC_AT_MINUS30)) + MIN_TEMP;
+                current_temperature = (((MAX_TEMP - MIN_TEMP)*((int32_t)ADC_values[TEMP_CHANNEL] - TEMP_SENSOR_ADC_AT_MINUS30))/(TEMP_SENSOR_ADC_AT_PLUS100 - TEMP_SENSOR_ADC_AT_MINUS30)) + MIN_TEMP;
                 temperature_accum -= sys_data.s.temperature;
                 temperature_accum += current_temperature;