LTspice 24.0.9 for Windows
Circuit: * D:\projekte\ecs_greencontroller\branches\gc75_40_V2\simulation\buck4_output_lisnmit_poly.asc
Start Time: Wed May  1 16:34:11 2024
solver = Normal
Maximum thread count: 24
tnom = 27
temp = 27
method = modified trap
trtol = 1
c6: Increased Cpar to 1e-11
c27: Increased Cpar to 2.2e-11
c28: Increased Cpar to 3.3e-10
c42: Increased Cpar to 4.7e-11
c43: Increased Cpar to 4.7e-11
c44: Increased Cpar to 3.3e-10
c4: Increased Cpar to 2.2e-11
c1: Increased Cpar to 2.2e-11
c20: Increased Cpar to 2.2e-11
c8: Increased Cpar to 3.3e-10
c9: Increased Cpar to 3.3e-10
c10: Increased Cpar to 3.3e-10
c11: Increased Cpar to 3.3e-10
c12: Increased Cpar to 3.3e-10
c13: Increased Cpar to 3.3e-10
c14: Increased Cpar to 3.3e-10
c15: Increased Cpar to 3.3e-10
c16: Increased Cpar to 3.3e-10
c17: Increased Cpar to 3.3e-10
c46: Increased Cpar to 1e-11
c47: Increased Cpar to 1e-11
c48: Increased Cpar to 1e-11

WARNING: Less than two connections to node vcc.  This node is used by r2.
Early termination of direct N-R iteration.
Direct Newton iteration failed to find .op point.  (Use ".option noopiter" to skip.)
Starting Gmin stepping
Gmin = 10
Gmin = 1.07374
vernier = 0.5
vernier = 0.25
vernier = 0.125
vernier = 0.0625
vernier = 0.03125
vernier = 0.015625
vernier = 0.0078125
vernier = 0.00390625
Gmin = 0.858993
vernier = 0.00195312
vernier = 0.000976562
vernier = 0.000488281
Gmin = 0
Gmin stepping failed

Starting source stepping with srcstepmethod=0
Source Step = 3.0303%
Source Step = 33.3333%
Source Step = 63.6364%
Source Step = 93.9394%
Source stepping succeeded in finding the operating point.

Ignoring empty pin current: Ix(u1:12)
Ignoring empty pin current: Ix(u1:12)
Heightened Def Con from 0.00572 to 0.00572
Total elapsed time: 806.566 seconds.